Coupled infrared extinction spectra and size distribution measurements for several non-clay components of mineral dust aerosol (quartz, calcite, and dolomite)

Simultaneous size distributions and Fourier transform infrared (FTIR) extinction spectra have been measured for several representative components of mineral dust aerosol (quartz, calcite, and dolomite) in the fine particle size mode (D=0.1–1 μm). Optical constants drawn from the published literature have been used in combination with the experimentally determined size distributions to simulate the extinction spectra. In general, Mie theory does not accurately reproduce the peak position or band shape for the prominent IR resonance features in the 800–1600 cm⁻¹ spectral range. The resonance peaks in the Mie simulation are consistently blue shifted relative to the experimental spectra by 20–50 cm⁻¹. Spectral simulations, derived from a simple Rayleigh-based analytic theory for a “continuous distribution of ellipsoids” particle shape model, better reproduce the experimental spectra, despite the fact that the Rayleigh approximation is not strictly satisfied in these experiments. These results differ from our previous studies of particle shape effects in silicate clay mineral dust aerosols where a disk-shaped model for the particles was found to be more appropriate.     

全工班呼吸性粉尘测定及防尘措施研究

针对呼吸性粉尘对矿井工人身体健康的危害,对煤矿综采工作面、综掘工作面、炮掘工作面等进行分工种个体性的全尘和呼尘监测,测定了各工作面粉尘(全尘和呼尘)的浓度、粉尘分散度和SiO2浓度。其结果表明:全工班呼吸性粉尘测定的方法更加真实可靠,更真实地反映了呼吸性粉尘对井下各操作工种的致病危害,测得的各工作面各工种的呼尘浓度均高于国家标准。通过数据的分析以及工人的建议,提出了一些新式的、有效的防尘措施来降低呼吸性粉尘对人体健康的危害。     

安钢第二炼轧厂转炉炼钢粉尘处理

介绍了安钢第二炼轧厂转炉炼钢采用脉冲布袋除尘回收与利用、工作原理、和减少对环境污染排放。     

甲烷-煤尘复合火焰的传播与温度特征

为了揭示甲烷-煤尘复合体系的燃烧特征,利用高速摄像机、超细热电偶、显微镜头等对管道内甲烷-煤尘复合火焰的传播过程及其温度特征进行了试验研究.结果表明,随着煤尘浓度的增加,甲烷-煤尘复合火焰的最高温度及传播速度呈现先增大后减小的趋势; 对于甲烷-煤尘复合火焰,粒径较大的煤尘在较小的浓度达到最高温度,而粒径较小的煤尘则需要在较大的浓度达到最高温度.     

Implementation of a windblown dust parameterization into MODELS-3/CMAQ: Application to episodic PM events in the US/Mexico border

Windblown dust is known to impede visibility, deteriorate air quality and modify the radiation budget. Arid and semiarid areas with unpaved and unvegetated land cover are particularly prone to windblown dust, which is often attributed to high particulate matter (PM) pollution in such areas. Yet, windblown dust is poorly represented in existing regulatory air quality models. In a study by the authors on modeling episodic high PM events along the US/Mexico border using the state-of-the-art CMAQ/MM5/SMOKE air quality modeling system [Choi, Y.-J., Hyde, P., Fernando, H.J.S., 2006. Modeling of episodic particulate matter events using a 3D air quality model with fine grid: applications to a pair of cities in the US/Mexico border. Atmospheric Environment 40, 5181–5201], some of the observed PM₁₀ NAAQS exceedances were inferred as due to windblown dust, but the modeling system was incapable of dealing with time-dependent episodic dust entrainment during high wind periods. In this paper, a time-dependent entrainment parameterization for windblown dust is implemented in the CMAQ/MM5/SMOKE modeling system with the hope of improving PM predictions. An approach for realizing windblown dust emission flux for each grid cell over the study domain on an hourly basis, which accounts for the influence of factors such as soil moisture content, atmospheric stability and wind speed, is presented in detail. Comparison of model predictions with observational data taken at a pair of US/Mexico border towns shows a clear improvement of model performance upon implementation of the dust emission flux parameterization.     

河北省钢铁工业主要大气污染物减排潜力分析

通过对河北省钢铁工业存在问题的分析,得出我省钢铁行业主要大气污染物为二氧化硫和粉尘.结合我省钢铁企业的实际情况,从工程技术、政策管理等方面提出相应治理措施,并对"十一五"期间我省钢铁行业二氧化硫和粉尘减排效益进行预测.预测结果显示:采用所建议的减排措施后,我省钢铁工业二氧化硫减排量对全省"十一五"减排计划的贡献率为81.4%;粉尘可减排60%.     

基于综采面产尘分布与扩散分析的粉尘防治研究

在对W3709综采工作面产尘特点分析的基础上,将工作面产尘源分为落煤扬尘、落煤冲击产尘及割煤产尘3类。对采煤机顺风割煤与逆风割煤时粉尘运动规律进行了详细的分析,根据工作面产尘特点与粉尘运动规律,提出了包括煤层注水、采煤机割煤产尘治理与控制以及支架处粉尘治理一套完整的综合防尘系统。通过现场应用,工作面粉尘在原有设施降尘基础上降低86%以上,降尘效果良好,有效地解决了该工作面粉尘污染严重的难题。     

石英砂加工企业职业病危害防护措施与管理对策研究

通过对安徽省石英砂加工企业生产工艺流程和现场进行调查分析,得出矽尘和噪声是两种最主要的职业病危害因素,发现石英砂生产企业矽尘和噪声危害十分严重,生产作业现场未配备任何防护装备和个人防护用品,作业人员接触职业病危害的比率非常高。分析了石英砂加工企业在职业病危害防护与管理方面的欠缺与不足,提出了针对矽尘和噪声危害因素的具体工程防护措施与管理对策,从源头控制和消除职业病危害,保护劳动者的生命安全与健康。     

喷嘴直径对降尘效果影响的试验研究

为提高喷雾降尘效率,以改善作业环境,有必要研究喷嘴直径与降尘效果间的关系。基于自行设计的喷雾降尘试验系统,采用马尔文实时高速喷雾粒度分析仪、高速摄像仪及粉尘浓度测定仪对不同直径喷嘴的雾化特性参数和降尘效率进行测定。结果表明,在相同喷雾压力下,随着喷嘴直径的增大,全尘降尘效率持续增加,而呼吸性粉尘降尘效率先增加后减小,并在喷嘴直径为1.5 mm时达到最大值;在耗水量相同的情况下,随着喷嘴直径的增大,全尘和呼吸性粉尘降尘效率均下降。在井下喷雾降尘中,当耗水量不受限制时,为同时确保全尘和呼吸性粉尘降尘效率,宜选择直径为1.5 mm的喷嘴;当耗水量受限制时,宜选择直径为1.2 mm的喷嘴。     

基于两种样品前处理方法对比研究小冬克玛底冰川雪坑中痕量元素

通过对唐古拉山小冬克玛底冰川雪坑中非季风季节沉积的雪样分别进行酸化处理和消解处理后,利用高分辨扇形磁场等离子体质谱仪(ICP-SFMS)测试了样品中19种痕量元素(Ba、U、Sr、Rb、Tl、Mo、Cs、Pb、Sb、V、Cr、Mn、Fe、Co、Al、Cu、Ti、Li、As)的酸化浓度和总浓度.研究结果表明,痕量元素浓度的变化范围较大,元素Al的最大/最小浓度比为326(酸化浓度)和465(总浓度),元素Pb相应比值为27和48.雪冰中痕量元素的总浓度一般大于该元素的酸化浓度,其中,元素Pb、Fe、Sb、Ba、Al、Ti的酸化浓度占总浓度的平均比值分别为91%、76%、60%、52%、33%和21%.一般地,样品中不溶微粒含量越大,酸化浓度占总浓度的比值越小;不溶微粒含量越小,则相反.对痕量元素的富集系数(EF)分析表明,各元素总浓度EF均值小于酸化浓度EF均值,揭示了用酸化浓度计算EF存在对痕量元素人为来源影响的高估.人类排放是小冬克玛底冰川中痕量元素的来源之一,对于元素Mo和Sb,人类排放估计是主要来源.利用后向轨迹模型模拟出小冬克玛底冰川雪冰中痕量元素在非季风季节主要来源于青藏高原西部及中亚中东地区.